Remove The Air Baffle; Remove The Pci Riser Cage - HP ProLiant DL60 Gen9 Maintenance And Service Manual

Place the server on a sturdy, level surface.
5.

Remove the air baffle

CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server (on page 26).
1.
If you are performing a non-hot-plug procedure, remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 27).
o
Remove the access panel
4.
Remove the air baffle.
5.

Remove the PCI riser cage

CAUTION:
disconnect all power cords before removing or installing the PCI riser cage.
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
For proper cooling, do not operate the server without the access panel, baffles,
("Access panel" on page 33).
To prevent damage to the server or expansion boards, power down the server, and
Removal and replacement procedures 28