Table of Contents
Advertisement
Parameters
Command Example
perf.preferredPath.setPath
Syntax
Purpose
the preferred path. All configured paths can be removed by
specifying the all parameter for both the destination domain ID and
source port.
This command has the following parameters.
destDomainId
Specifies the destination domain ID. Valid
domain IDs are in the range 1–31 or all, which
deletes all preferred paths to and from the
source port specified in the sourcePort
parameter.
sourcePort
Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or you can specify all to delete all paths to the
destination domain ID.
Root> perf preferredPath clearPath 10 5
setPath destDomainID sourcePort exitPort
This command sets a preferred exit port given the destination domain
ID and source port. An exit port can be set for each combination of
destination domain ID and source port.
NOTE: You cannot set a path where the Destination Domain ID is the same as
the Switch's Domain ID.
perf
CLI Commands
2-111
2
Advertisement
Table of Contents
