Table of Contents
Advertisement
config
config.enterpriseFabMode.setState
Syntax
Purpose
Parameters
•
show.port.opticInfo
on page 2-170
•
show.port.profile
on page 2-171
•
show.port.showPortAddr
•
show.security.log
on page 2-181
•
show.security.switchAcl
The config branch of the CLI command tree contains commands that
set parameter values on the switch or director. These values are not
temporary (session) values, but are retained across power cycles.
The commands in the config branch can only be accessed by a user
with administrator level user rights.
CLI commands are activated on the switch immediately, except as
noted.
In general, the config naming commands (except for the
config.zoning commands) use the USASCII character set. All of the
characters in this 128-character set (the first 7-bit subset of the
ISO-8859-1 Latin-1 character set) are valid. Any exceptions are noted
in the specific command descriptions.
setState enterpriseFabModeState
This command sets the Enterprise Fabric Mode state for the fabric.
The SANtegrity™ feature key must be installed to activate the
Enterprise Fabric Mode state.
NOTE: The command
config.features.enterpriseFabMode
functionality that is identical to this command.
This command has one parameter.
enterpriseFabModeState
on page 2-173
on page 2-183
on page 2-6 has
Specifies whether enterpriseFabMode is
active. Valid values are activate and
deactivate. Boolean 1 and 0 may be
substituted as values.
config
CLI Commands
2-5
2
Advertisement
Table of Contents
