Table of Contents
Advertisement
config
2
Command Example
config.security.switchAcl.show
Command Example
Output Example
config.security.switchBinding
Enterprise Operating System Command Line Interface User Manual
2-64
Root> config security switchAcl setState 1
Syntax
show
Purpose
This command displays the contents of the access control list.
Parameters
This command has no parameters.
Root> config security switchACL show
Output
This command displays the following access control list information:
Starting IP
Address
Ending IP
Address
The output from the config.security.switchAcl.show command
displays as follows.
ACL State:
Starting IP Address
-------------------
110.80.1.1
110.81.1.10
200.11.15.1
Switch Binding CLI commands allow you to enable the product to
communicate only with nodes, switches, and directors that are listed
on the Switch Binding Membership List (SBML). Switch Binding
restricts connections to only the devices listed on the SBML and
allows no other devices to communicate with the switch. When an
unauthorized WWN attempts to log in, it is denied a connection and
an event is posted to the Event Log. This provides security in
environments that include a large number of nodes, switches, and
directors by ensuring that only the specified set of WWNs are able to
attach to the managed product.
The starting IP Address of the range in the
access control list.
The ending IP Address of the range in the
access control list.
Disabled
Ending IP Address
-----------------
110.80.255.255
110.81.1.255
200.11.255.128
Advertisement
Table of Contents
