Config.switch.prefdomainid; Config.switch.priority - McDATA Enterprise Operating System User Manual

Purpose
Parameters
Command Example

config.switch.prefDomainId

Syntax
Purpose
Parameters
Command Example

config.switch.priority

Syntax
Purpose
This command sets the status of limited fabric RSCNs. When enabled,
fabric register for state change notifications (RSCNs) are suppressed
during an IPL.
This command has one parameter.
ltdFabRSCNState Specifies whether the limited fabric RSCN state
is enabled. Valid values are enable and disable.
Boolean 1 and 0 may be substituted as values.
Root> config switch ltdFabRSCN 1
prefDomainId domainId
This command sets the preferred domain ID for the switch. The
switch must be offline to complete this command.
NOTE: The switch must be set offline before this command is entered.
This command has one parameter.
domainId Specifies the new preferred domain ID value.
This parameter must be an integer in the range
1–31.
Root> config switch prefDomainId 1
priority Priority
This command sets the switch priority.
NOTE: The switch must be set offline before this command is entered.
config
CLI Commands
2-75
2