Config.port.showportaddr - McDATA Enterprise Operating System User Manual

config
2
Command Example
Output Example

config.port.showPortAddr

Enterprise Operating System Command Line Interface User Manual
2-28
Root> config port show 4
Output This command displays as a table that includes the following
properties.
Port Number
Name
Blocked
FAN
Type
Speed
Rx BB Credits
The output from the config.port.show command displays as follows.
Port Number:
Name:
Blocked:
Type:
Speed:
Rx BB Credits:
Syntax
showPortAddr
Purpose This command displays the port address configuration for all ports.
NOTE: The command
that is the same as this command.
The port number.
The configured port name.
The blocked state. Valid values are true and false.
The fabric address notification (FAN) state. Valid
values are true and false. (Sphereon 4300 and
Sphereon 4500 switches only.)
The port type. Valid values are:
• F Port
• E Port
• G Port
• Fx Port (Sphereon 4300 and Sphereon 4500 only)
• Gx Port (Sphereon 4300 and Sphereon 4500 only)
The port speed. Valid values are 1 Gb/sec, 2 Gb/sec,
and Negotiate.
The number of configured Rx BB Credits.
4
Sam's tape drive
false
F Port
2 Gb/sec
12
show.port.showPortAddr on page 2-173 has functionality