Config.security.authentication.port.override - McDATA Enterprise Operating System User Manual

config
2
Command Example

config.security.authentication.port.override

Enterprise Operating System Command Line Interface User Manual
2-40
Parameters This command has one required parameter, and one optional
parameter:
method1
method2
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Root> config security authentication interface cli
sequence RADIUS local
Syntax
override
Purpose This command sets the outgoing override state for a single port. This
setting allows you to override the default outgoing authentication
state for either the E_port or N_port interface. The default setting will
cause the port to use the outgoing state configure for the
corresponding interface (either E_port or N_port).
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
This sets the preferred method of
authentication for the CLI interface.
Accepted values are local or RADIUS.
This optional parameter sets the backup
method of authentication for the CLI
interface. This backup method is used
when the preferred method cannot be
contacted. Accepted value is local.
portNumber [overrideState]