Table of Contents
Advertisement
Parameters
Command Example
perf.thresholdAlerts.throughput.setUtilPercentage
Syntax
Purpose
Parameters
Command Example
This command has the following parameters.
name
The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-129.
utilizationType
The type of traffic that triggers the alert. Enter
the number that corresponds to the desired
utilization type:
1 - Transmit Traffic (Tx)
2 - Receive Traffic (Rx)
3 - Both (Rx and Tx)
Root> perf thresholdAlerts throughput setUtilType
eportRx 1
setUtilPercentage name utilizationPercentage
This command sets the throughput utilization percentage that is used
to trigger the throughput threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
This command has the following parameters.
name
utilizationPercentage
Root> perf thresholdAlerts throughput setUtilPercentage
eportRx 70
The name of a throughput threshold alert
as defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-129.
The percentage of throughput utilization
that triggers the alert. This must be entered
as a number. Accepted values are in the
range 1 to 100.
perf
CLI Commands
2-133
2
Advertisement
Table of Contents
