Perf.thresholdalerts.counter.setparams - McDATA Enterprise Operating System User Manual

perf
2
Command Example

perf.thresholdAlerts.counter.setParams

Enterprise Operating System Command Line Interface User Manual
2-124
Parameters This command has the following parameters.
name
counterNumber
Root> perf thresholdAlerts counter setCounter checklinks 1
Syntax
setParams name increment interval
Purpose This command sets the increment and interval times for a specified
counter threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters
This command has the following parameters.
name
increment
interval
Example The meaning for each of these inputs can best be described using the
following example sentence:
The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert, described
on 2-120.
Specifies the counter number. Valid values are
shown in Table 2-3, Alert
The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert, described
on 2-120.
This sets the number of times a counter must
increment during the interval period to trigger
the alert. Acceptable values are in the range of
1 to 70,560.
This sets the interval time in minutes for the
alert. Acceptable values are in the range of 5 to
70,560 minutes.
Counters, page 2-118.