Table of Contents
Advertisement
Command Overview
2
Command Overview
New and Changed Commands
Enterprise Operating System Command Line Interface User Manual
2-2
Most of the commands in this chapter are listed in alphabetical order
to make them easy to locate. Although the commands can be entered
in any order, depending on the results desired (so long as the tree
structure is followed), the order used herein for the zoning
commands follows a typical order of entry. The various show
commands are usually entered at the end of a group of other
commands to verify configuration changes.
The following CLI commands are new for this edition of the
Enterprise Operating System Command Line Interface User Manual:
•
config.fencing.addPolicy
•
config.fencing.addPort
•
config.fencing.deletePolicy
•
config.fencing.removePort
•
config.fencing.setParams
•
config.fencing.setState
•
config.fencing.show
on page 2-14
•
config.fencing.showTypeTable
•
config.ficonCUPZoning.addControlHost
•
config.ficonCUPZoning.deleteControlHost
•
config.ficonCUPZoning.setState
•
config.ficonCUPZoning.show
•
config.ficonMS.setMIHPTO
•
config.ficonMS.show
•
config.ip.lineSpeed
on page 2-21
•
config.NPIV.maxPortIDs
•
config.NPIV.maxPortIDs
•
config.NPIV.setState
on page 2-10
on page 2-10
on page 2-11
on page 2-12
on page 2-12
on page 2-14
on page 2-16
on page 2-16
on page 2-17
on page 2-17
on page 2-18
on page 2-18
on page 2-20
on page 2-22
on page 2-22
on page 2-23
Advertisement
Table of Contents
