Config.security.switchacl.deleterange; Config.security.switchacl.setstate - McDATA Enterprise Operating System User Manual

Command Example

config.security.switchAcl.deleteRange

Syntax
Purpose
Parameters
Command Example

config.security.switchAcl.setState

Syntax
Purpose
Parameters
NOTE: The starting IP address must be lesser than the ending IP address.
Root> config security switchAcl addRange 10.0.0.0
10.0.0.2
deleteRange startIPAddress endIPAddress
This command deletes a range of IP addresses from the access control
list. This range must exactly match one of the existing ranges in the
access control list.
This command has the following parameters:
startIPAddress The starting IP Address of the range to be
deleted. The address must be entered in dotted
decimal form (such as, 10.0.0.0).
clear - Using the optional 'clear' parameter by
itself will remove all of the entries from the
access control list.
endIPAddress The ending IP Address of the range to be
deleted. The address must be entered in dotted
decimal form (such as, 10.0.0.0).
Root> config security switchAcl deleteRange 10.0.0.0
10.0.0.2
setState aclEnabledState
This command sets the enabled state of the access control list. In
order for the access control list to be enforced, the state must be set to
enable.
This command has one parameter:
aclEnabledState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be substituted.
config
CLI Commands
2-63
2