Config.zoning.deletewwnmem; Config.zoning.deletezone - McDATA Enterprise Operating System User Manual

config
2

config.zoning.deleteWwnMem

Command Example

config.zoning.deleteZone

Command Example
Enterprise Operating System Command Line Interface User Manual
2-90
Syntax
deleteWwnMem zoneName wwn
Purpose This command removes a WWN member from a zone that is in the
work area.
Parameters This command has two parameters.
zoneName
wwn
Root> config zoning deleteWwnMem TheNotSoUltimateZone
10:00:00:00:C9:22:9B:AB
Syntax
deleteZone zoneName
Purpose This command deletes a zone from the zone set in the work area.
NOTE: Changes are not activated on the switch until the
config.zoning.activeZoneSet command is issued.
Parameters
This command has one parameter.
zoneName
Root> config zoning deleteZone TheLeastUltimateZone
Specifies the name of the zone that contains the
member to be deleted.
Specifies the WWN of the member to be deleted
from the zone. The value of the WWN must be
in colon-delimited hexadecimal notation (for
example, AA:00:AA:00:AA:00:AA:00).
Specifies the name of the zone to be deleted.