Show.nameserver - McDATA Enterprise Operating System User Manual

show
2
Command Example
Output Example
Port BB Crdt
---- -------
0 10
1 10
4 10
7 10
8 10
10 10
11 10
12 10
13 10
15 10

show.nameServer

Enterprise Operating System Command Line Interface User Manual
2-156
more than one device per port for any public loop devices attached to
an FL Port.
Parameters
This command has no parameters.
Root> show loginServer
Output The device information is displayed as a table that includes the
following properties.
Port
BB Crdt
RxFldSz
COS
Port Name
Node Name
The output from the show.loginServer command displays as follows.
RxFldSz COS Port Name
------- --- -----------------------
2,3 00:11:22:33:44:55:00:77
2 00:11:22:33:44:55:00:78
2,3 00:11:22:33:44:55:00:79
2,3 00:11:22:33:44:55:00:80
2 00:11:22:33:44:55:00:81
2,3 00:11:22:33:44:55:00:82
2,3 00:11:22:33:44:55:00:83
3 00:11:22:33:44:55:00:84
2,3 00:11:22:33:44:55:00:85
2,3 00:11:22:33:44:55:00:86
Syntax
nameServer
The port number where the device is attached.
The maximum number of remaining frames
that can be transmitted without causing a buffer
overrun condition at the receiver.
The buffer-to-buffer receive data field size from
the FLOGI received from the attached N_Port.
The class of service (for example, 1; 2; 3; 4; 5; 6;
F; 1,2; 2,3).
The port WWN of the attached device.
The node WWN of the attached device.
Node Name
-----------------------
20:11:22:33:44:55:66:77
20:11:22:33:44:55:66:78
20:11:22:33:44:55:66:79
20:11:22:33:44:55:66:80
20:11:22:33:44:55:66:81
20:11:22:33:44:55:66:82
20:11:22:33:44:55:66:83
20:11:22:33:44:55:66:84
20:11:22:33:44:55:66:85
20:11:22:33:44:55:66:86