Extreme Networks EPICenter Software Installation Manual page 377

• Config Mgmt Log
These reports provide a set of fields at the top of the report similar to the ones shown in Figure 186.
Figure 186: Report filter specification
To create a filter, follow these steps:
1 In the first field, select the variable to use in the filter. The variables from which you can choose are
based on the column headings in the report, and depend on the type of report you are viewing.
2 In the second field, select a comparison operator. You can choose from the following comparison
operators:
— > (greater than)
— < (less than)
— <= (greater than or equal)
— >= (less than or equal)
— != (not equal)
— = (equal)
— starts with
— ends with
— contains
If the variable values are strings, then the comparisons are taken to indicate alphabetic order, where
greater than indicates later in later in the alphabet (for example, the letter B is greater than A).
3 In the third field, select the value you want to compare the variable against. If the variable takes a
string as its value, enter a string. If the variable is numeric, enter an integer.
NOTE
You can use the browser Copy and Paste functions to copy a specific value from the current report
into the comparison field.
4 In the fourth field, you can indicate whether the second condition should be used. To use a second
condition to your filter, choose one of the logical operators And or Or. Specify And to include a row
in the report only if both conditions are true. Select Or to include the row if either one (or both) of
the conditions are true.
If you do not want to include a second condition, select NIL to indicate that the second clause should be
ignored.
5 Click Filter to generate the report based on the filter you have specified.
Click Remove Filter to remove the filter definition and generate an unfiltered report.
EPICenter Software Installation and User Guide
Viewing Predefined EPICenter Reports
377