Extreme Networks EPICenter Software Installation Manual page 398

Voice over IP Manager
When you run the VoIP applet for the first time, and have not yet selected any VLANs for VoIP, the
table shown on this page will be empty.
2 Click the Select button at the top of the VoIP window. This displays the Select Voice over IP VLANs
window, as shown in Figure 195.
Figure 195: Select Voice over IP window
In this window you can select individual VLANs, and enable or disable VoIP for that VLAN.
The Select Voice over IP VLANs table shows information about each switch in the selected VLAN:
• Enabled: A green check indicates that this switch is selected as part of the VoIP VLAN. A red X
indicates that this device has not been selected (or has been deselected). As a rule, all devices in
the VLAN will be enabled or disabled for VoIP, and switches cannot be enabled or disabled
individual. However, if a device is added to the VLAN after the VLAN has been enabled, that
switch will not be enabled until you re-enable the entire VLAN.
• IP Address: The IP address assigned to the VLAN on the switch. This may be blank if the VLAN
does not have an IP address assigned (as is the case with the Default VLAN).
• Switch: The name of the switch.
• QoS Profile: The QoS profile assigned to this VLAN on this switch.
• Priority: The priority associated with the QoS profile.
• Min Bw: The minimum bandwidth for this QoS profile.
• Max Bw: The maximum bandwidth for this QoS profile.
The VoIP Manager applet assumes that you have already set up the VLANs you will be using for
your VoIP traffic.
3 To display a VLAN, pull down the list of VLANs from the All VLANs field at the top of the
window, and select a VLAN, as shown in Figure 196.
398 EPICenter Software Installation and User Guide