ERS-4 Instruction Manual
2.6 Monitor connection
For service and installation the ERS-4 can be operated by mouse at a local connected monitor.
All functions except playback and export are available at local operation.
The ERS-4 provides a composite Video output (BNC) and a VGA output (resolution 800x600 @ 60Hz) with
similar functionality. Depending on monitor type select one of these video outputs for monitor installation.
2.7 NETWORK CONNECTION
This section only describes physical connection to an Ethernet network. This step must be completed
before the ERS-4's can connect to the network. Appendix C describes more Details for network
installations.
There are two basic types of connection:
2.7.1 Direct PC Connection through Crossover Network Cable
The point-to-point connection of ERS-4 and PC requires a crossover (crossed) network cable. This type of
connection is ONLY used for direct connection to a single PC. Make sure that the PC is equipped with a
10/100/1000 Mbps compatible network connection.
Figure 2-1 Direct PC Connection
11