Required ERS-4 settings:
ATTENTION: Some Pelco-D / -P protocol domes and receivers require an address offset of -1, i.e. the
address assigned to the dome / receiver in the ERS-4 camera menu must be 1 below the address set in the
dome / receiver itself!
2.5 USB-MOUSE INSTALLATION
For service and installation the ERS-4 can be operated by mouse at a local connected monitor.
All functions except playback and export are available at local operation.
Connect the USB mouse to the back panel USB port.
NOTE: Recommended mouse types are Logitech® and Microsoft® wired USB wheel-mouse. Wireless
USB mouse is not supported.
RS-485 receiver address in CAMERA menu
RS-485 parameters and protocol in the I/O CONTROL menu
10
ERS-4 Instruction Manual