Ptz Control - EverFocus ERS-4 Instruction Manual

4.6 PTZ CONTROL

If the connected camera is defined as a PTZ device (Speed Dome, PTZ head with RS-485 receiver), the
PTZ control panel is shown at left side after clicking on
Required settings: 1. PTZ is enabled and RS-485 address is entered in CAMERA > BASIC SETTING.
2. RS-485 parameter are adjusted in SYSTEM > I/O CONTROL.
Input syntax:
Go to Preset Position
Save Preset Position
Delete Preset Position
Start Preset Tour
Start Pattern
Start Auto-Pan
Open Setup Menu
Enter in Speed Dome OSD
ESC / Cancel in Speed Dome OSD
NOTE: The availability of each PTZ feature depends on user camera type and used PTZ protocol !
Pan - Tilt direction keys
Zoom in (+) , Zoom out (-)
Focus far (+), Focus near (-)
Iris open (+), Iris close (-)
Input field for preset, tour and pattern numbers
Number buttons
Clear numeric input
Start (for preset, tour, pattern
Save preset position
Delete preset position
Auto-Pan
Preset position
Preset Tour
Pattern
PRESET > [number] > GO
PRESET > [number] > SET
PRESET > [number] > DELETE
TOUR > [number] > GO
PATTERN > [number] > GO
AUTO-PAN
PRESET > [95] > SET
I+ ((iris open)
I- (Iris close)
75
button.
ERS-4 Instruction Manual