Speed Dome Installation; Usb Mouse Installation; Network Connection; Direct Pc Connection Through Crossover Network Cable - EverFocus PARAGON 264x1 User Manual

16ch dvr

Table of Contents

RS-485 port communication settings are configured in the I/O CONTROL menu (Section 5.10.4 System Setup: I/O - control).

1.9.5 Speed Dome Installation

A speed dome or telemetry receiver's motor functions can be controlled through a web browser or the optional PowerCon

software if the DVR is connected to a network. Local PTZ/telemetry control can be done via USB mouse or by the optional

EKB-500 keyboard.

Supported protocols: EverFocus, Pelco-D, Pelco-P, Samsung, Transparent

Required DVR settings:

1) Enter the RS-485 receiver address (PTZ ID) in the Camera Setting > Basic Setting submenu of the Configuration menu.

2) Enter the RS-485 parameters and protocol in the System Setting > I/O Control submenu of the Configuration menu.

ATTENTION:

Some Pelco-D / -P protocol domes and receivers require an address offset of -1, i.e. the address assigned

to the dome / receiver in the DVR camera menu must be 1 below the address set in the dome / receiver itself!

Connect the USB mouse to one of the two USB ports. (This can be done while the DVR is powered on).

NOTE: Recommended mouse types are the Logitech® and Microsoft® wired USB wheel-mice. Wireless USB mice are not

supported.

This section only describes the physical connection to an Ethernet network. This step must be completed before the DVR

can connect to the network. There are two basic types of connection:

The point-to-point connection of DVR and PC requires a crossover (crossed) network cable (Ethernet cable). This type of

connection is ONLY used for direct connection to a single PC. Make sure that the PC is equipped with a 10/100Mbps

compatible network connection.

Direct PC Connection:

Pinout of crossover-cable:

Table of Contents