Speed Dome Installation; Connection; Rs-232 C Onnection; Usb-Mouse Installation - EverFocus PARAGON Series Instruction Manual

2.4.5 Speed Dome Installation

Speed dome or telemetry receiver pan/tilt/zoom control is available through web browser or the optional
PowerCon software if the DVR is connected to a network. Local telemetry control is provided by USB -
mouse control or by the optional EKB-500 keyboard.
Supported protocols: EverFocus, Pelco-D, Pelco-P, Samsung, Transparent
Required DVR settings: RS-485 receiver address in CAMERA menu
ATTENTION: Some Pelco-D / -P protocol domes and receivers require an address offset of -1, i.e. the
address assigned to the dome / receiver in the DVR camera menu must be 1 below the address set in the
dome / receiver itself!
2.5 RS-232 Connection
1 2 3 4
6 7 8
9

2.6 USB-Mouse installation

Connect the USB mouse to one of the 2 USB ports. (This can be done while DVR is powered on)
NOTE: Recommended mouse types are Logitech® and Microsoft® wired USB wheel-mouse. Wireless
USB mouse is not supported.
( chapter 5.10.4.)
RS-485 parameters and protocol in the I/O CONTROL menu
( chapter 5.10.4.)
5
Pin
2
3
5
Function
TXD
RXD
Ground
18