Setting Up Sata Raid Or Ahci Modes; Ahci Mode; Raid - EUROCOM Notebook V09.1.00 User Manual

Modules
SATA Mode
Selection
If you have installed the
Windows Vista operat-
ing system with either
AHCI or RAID mode en-
abled, DO NOT disable
the set mode (if you wish
to disable the set mode
you will need to reinstall
7
the Windows VIsta OS).

7 - 2 Setting Up SATA RAID or AHCI Modes

Setting Up SATA RAID or AHCI Modes

AHCI Mode

Advanced Host Controller Interface (AHCI) is an interface specification that allows
the storage driver to enable advanced serial ATA features such as Native Command
Queuing (for maximum hard disk efficiency and performance). AHCI mode can be
supported by one or two hard disks.

RAID

You may use your hard disks (if you have included more than one hard disk in your
purchase option) in combination with Striping (RAID 0) or Mirroring (RAID 1) for
either fault tolerance or performance (see
your system in Striping (RAID 0) or Mirroring (RAID 1) modes you will require at
least two hard disks.
Table 7 - 1, on page 7 - 4). To configure