Raid Mode Setup - EUROCOM Notebook V09.1.00 User Manual

RAID Mode Setup

1. Start-up your notebook computer and press <F2> to enter the BIOS.
2. Go to the Advanced menu, select "SATA Mode Selection" and press Enter (see
page 5 - 7).
Phoenix SecureCore(tm) Setup Utility
Main A A dvanced Advanced
Integrated Devices
Installed O/S:
SATA Mode Selection:
Legacy USB Support:
Boot-time Diagnostic Screen:
Power On Boot Beep
Battery Low Alarm Beep:
Only available if Windows Vista
is selected as the O/S.
F1 Help Select Item
Esc Exit Select Menu
3. Select "RAID" or "AHCI".
4. Press Esc and go to the Boot menu.
5. Set the CD/DVD-ROM Drive (make sure the Microsoft Windows OS CD is
inserted) as the first device in the boot order from the Boot menu.
6. Select Exit Saving Changes from the Exit menu (or press F10 and Enter) and
press Enter to exit the BIOS and reboot the computer.
Security Boot Exit
[Windows VISTA]
[RAID]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
- / + Change Values
Enter Select Sub-Menu
Item Specific Help
Determines how SATA
controller(s) operate.
Note: An incorrect
setting can cause
some operating
systems to display
unexpected behavior.
F9 Setup Defaults
F10 Save and Exit
Modules
Figure 7 - 1
BIOS > Advanced
(SATA Mode
Selection)
RAID Setup 7 - 5
7