Setting Up Sata Raid Or Ahci Modes; Ahci Mode; Raid - EUROCOM Notebook User Manual

Modules

Setting Up SATA RAID or AHCI Modes

AHCI Mode

Advanced Host Controller Interface (AHCI) is an interface specification that allows
the storage driver to enable advanced serial ATA features such as Native Command
Queuing (for maximum hard disk efficiency and performance). AHCI mode can be
supported by one, two or three hard disks.

RAID

You may use your hard disks (if you have included more than one hard disk in your
purchase option) in combination with Striping (RAID 0), Mirroring (RAID 1) or
7
Parity Across Disks (RAID 5) for either fault tolerance or performance (see Table 7
- 1, on page 7 - 3). To configure your system in Striping (RAID 0) or Mirroring
(RAID 1) modes you will require at least two hard disks; to configure your system
in Parity Across Disks (RAID 5) mode you will require three hard disks installed.
7 - 2 Setting Up SATA RAID or AHCI Modes