EUROCOM Notebook V09.1.00 User Manual page 184

Troubleshooting
Problem
Nothing appears on the
screen when the PC
Camera software is run.
A file cannot be copied
to/from a connected
Bluetooth device.
The Bluetooth module is
8 off after resuming from
Sleep.
No sound can be heard
through an
connected display
device.
8 - 12 Problems & Possible Solutions
You have selected an external display as the default display device. The PC Camera application
software needs to be run while the default notebook LCD is the selected display device.
After a camera picture is obtained on the default notebook LCD, you may then use the Fn + F7 to
toggle through the display modes (give the screen time to refresh).
If you have selected an external display as your display device do not run the PC Camera
software application until you have switched back to the notebook LCD.
The transfer of data between the computer and a Bluetooth enabled device is supported in one
direction only (simultaneous data transfer is not supported). If you are copying a file from
your computer to a Bluetooth enabled device, you will not be able to copy a file from the Bluetooth
enabled device to your computer until the file transfer process from the computer has been
completed
The Bluetooth module's default state will be off after resuming from the Sleep power-saving state.
Use the key combination (Fn + F12) to power on the Bluetooth module after the computer
resumes from Sleep.
You have not configured the HDMI audio output. See
HDMI 8.
Possible Cause - Solution
"HDMI Audio Configuration" on page B -