Self Test Procedure For Cm401, Cm402 And Cm408 - Euphonix System 5 Control Surface/Frame Manual

Self Test Procedure for CM401, CM402 and CM408

(For CM40x Firmware Rev 1.0S)
The following pages describe the operation of standalone self test software for
System-5 control modules.
The self-test code is designed to be invoked in a module right after power-up and
before the SBC downloads code into the control module 386 board.
The self-test works in a fully assembled module as well as with just the upper
board or just the lower board connected to the CPU board. However, the upper board
must be present to run fader test modes.
All the three types of control modules have the same lower board. Because of this,
the lower board can be tested separately without an upper board connected. The self-
test can be invoked from the lower board knobs as well as upper board self test keys.
S5 Control Surface/Frame Manual Page 30 Version 1.0 ©1999 Euphonix, Inc.