Configuring Static Network Information On The Oob Port; Configuring Static Network Information On The Default Vlan - Dell Networking 7048 Configuration Manual

Configuring Static Network Information on the OOB Port

Beginning in Privileged EXEC mode, use the following commands to
configure a static IP address, subnet mask, and default gateway on the OOB
port.
Command
configure
interface out-of-band
ip_address
ip address
subnet_mask gateway_ip
[
CTRL + Z
show ip interface out-of-band Verify the network information for the OOB port.

Configuring Static Network Information on the Default VLAN

Beginning in Privileged EXEC mode, use the following commands to
configure a static IP address, subnet mask, and default gateway on the default
VLAN.
Command
configure
interface vlan 1
ip_address
ip address
subnet_mask
prefix/prefix-length
ipv6 address
[eui64]
ipv6 enable
exit
ip default-gateway
exit
show ip interface vlan 1
show ipv6 interface vlan 1
136
Setting Basic Network Information
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for the OOB
port.
Configure a static IP address and subnet mask.
] Optionally, you can also configure a default gateway.
Exit to Privileged EXEC mode.
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for VLAN 1.
Enter the IP address and subnet mask.
Enter the IPv6 address and prefix.
Enable IPv6 on the interface.
Exit to Global Configuration mode
ip_address
Configure the default gateway.
Exit to Privileged Exec mode.
Verify the network information for VLAN 1.
Verify IPv6 network information for VLAN 1.