Snmp Host Table - D-Link xStack DGS-3324SRi User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual

SNMP Host Table

Use the SNMP Host Table to set up SNMP trap recipients.
Open the SNMP Manager folder and click on the SNMP Host Table link. This will open the SNMP Host Table page, as
shown below.
To delete an existing SNMP Host Table entry, click the corresponding
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host
IP Address heading.
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the page.
This will open the SNMP Host Table Configuration page, as shown below.
The following parameters can set:
Parameter
Host IP Address
SNMP Version
Community String or
SNMP V3 User Name
To implement your new settings, click Apply. To return to the SNMP Host Table, click the
Entries link.
Figure 8- 10. SNMP Host Table
Figure 8- 11. SNMP Host Table Configuration window
Description
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
V1 - To specify that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a
NoAuth-NoPriv security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-
NoPriv security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv
security level.
Type in the community string or SNMP V3 user name as appropriate.
under the Delete heading.
243
Show All SNMP Host Table