xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
Bandwidth Control
The bandwidth control settings are used to place a ceiling on the transmitting and receiving data rates for any selected port.
In the Configuration folder, click QoS > Bandwidth Control, to view the screen shown below.
Figure 6- 46. Bandwidth Settings and Port Bandwidth Table window
The following parameters can be set or are displayed:
Parameter
Unit
From/To
Type
No Limit
Rate
Click Apply to set the bandwidth control for the selected ports. Results of configured Bandwidth Settings will be
displayed in the Port Bandwidth Table.
Description
Choose the Switch ID number of the Switch in the switch stack to be modified.
A consecutive group of ports may be configured starting with the selected port.
This drop-down menu allows a selection between RX (receive,) TX (transmit,) and
Both. This setting will determine whether the bandwidth ceiling is applied to receiving,
transmitting, or both receiving and transmitting packets.
This drop-down menu allows the user to specify that the selected port will have no
bandwidth limit. Enabled disables the limit.
This field allows the input of the data rate, in Mbit/s, that will be the limit for the
selected port. The user may choose a rate between 1 and 9999 Mbit/s.
89