D-Link xStack DGS-3324SRi User Manual page 221

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
The following fields can be set:
Parameter
Interface Name
IP Address
Designated Router
Hello Interval
Join/Prune Interval
Mode
State
DR priority
Click Apply to implement changes made.
Figure 6- 170. PIM Interface Settings – Edit window
Description
This read-only field denotes the IP interface selected to be configured for PIM.
This read-only field denotes the IP address of the IP interface selected to be configured
for PIM.
This read-only field denotes the IP address of the Designated Router of the distribution
tree to which this IP address belongs.
This field will set the interval time between the sending of Hello Packets from this IP
interface to neighboring routers one hop away. These Hello packets are used to
discover other PIM enabled routers and state their priority as the Designated Router
(DR) on the PIM enabled network. The user may state an interval time between 1 –
18724 seconds with a default interval time of 30 seconds.
This field will set the interval time between the sending of Join/Prune packets stating
which multicast groups are to join the PIM enabled network and which are to be
removed or "pruned" from that group. The user may state an interval time between 1 –
18724 seconds with a default interval time of 30 seconds.
Use the pull-down menu to select the type of PIM protocol to use, Sparse Mode (SM) or
Dense Mode (DM). The default setting is DM.
Use the pull-down menu to enable or disable PIM for this IP interface. The default is
Disabled.
Enter the priority of this IP interface to become the Designated Router for the multiple
access network. The user may enter a DR priority between 0 and 4,294,967,294 with a
default setting of 1.
206