D-Link xStack DGS-3324SRi User Manual page 166

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the combination type_1
type_2 is functionally equivalent to external. Entering the combination internal external is functionally equivalent to all.
Entering the metric 0 specifies transparency.
This window will redistribute routing information between the OSPF and RIP routing protocols to all routers on the
network that are running OSPF or RIP. To access the Route Redistribution Settings window, go to Configuration >
Layer 3 IP Networking > Route Redistribution Settings:
The following parameters may be set or viewed:
Parameter
Dst. Protocol
Src. Protocol
Type
Metric
Click Add/Modify to implement changes made.
Figure 6- 116. Route Redistribution Settings and Table window
Description
Allows for the selection of the protocol for the destination device. Choose between RIP
and OSPF.
Allows for the selection of the protocol for the source device. Choose between RIP,
OSPF, Static and Local.
Allows for the selection of one of six methods of calculating the metric value. The user
may choose between All, Internal, External, ExtType1, ExtType2, Inter-E1, Inter-E2.
See the table above for available metric value types for each source protocol.
Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in the
RIP routing protocol. The user may specify a cost between 0 and 16.
NOTE: The source protocol (Src. Protocol) entry and the destination
protocol (Dst. Protocol) entry cannot be the same.
151