Edge Port; P2P Port; 802.1D / 802.1W / 802.1S Compatibility - D-Link xStack DGS-3324SRi User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
discarding, there is no functional difference, the port is not active in the network topology. Table 6-1 below compares how
the three protocols differ regarding the port state transition.
All three protocols calculate a stable topology in the same way. Every segment will have a single path to the root bridge.
All bridges listen for BPDU packets. However, BPDU packets are sent more frequently - with every Hello packet. BPDU
packets are sent even if a BPDU packet was not received. Therefore, each link between bridges is sensitive to the status of
the link. Ultimately this difference results in faster detection of failed links, and thus faster topology adjustment. A draw-
back of 802.1d is this absence of immediate feedback from adjacent bridges.
802.1d MSTP
Discarding
Discarding
Discarding
Learning
Forwarding
RSTP is capable of a more rapid transition to a forwarding state - it no longer relies on timer configurations - RSTP
compliant bridges are sensitive to feedback from other RSTP compliant bridge links. Ports do not need to wait for the
topology to stabilize before transitioning to a forwarding state. In order to allow this rapid transition, the protocol
introduces two new variables: the edge port and the point-to-point (P2P) port.

Edge Port

The edge port is a configurable designation used for a port that is directly connected to a segment where a loop cannot be
created. An example would be a port connected directly to a single workstation. Ports that are designated as edge ports
transition to a forwarding state immediately without going through the listening and learning states. An edge port loses its
status if it receives a BPDU packet, immediately becoming a normal spanning tree port.

P2P Port

A P2P port is also capable of rapid transition. P2P ports may be used to connect to other bridges. Under RSTP/MSTP, all
ports operating in full-duplex mode are considered to be P2P ports, unless manually overridden through configuration.

802.1d / 802.1w / 802.1s Compatibility

MSTP or RSTP can interoperate with legacy equipment and is capable of automatically adjusting BPDU packets to 802.1d
format when necessary. However, any segment using 802.1d STP will not benefit from the rapid transition and rapid
topology change detection of MSTP or RSTP. The protocol also provides for a variable used for migration in the event that
legacy equipment on a segment is updated to use RSTP or MSTP.
The Spanning Tree Protocol (STP) operates on two levels:
1. On the switch level, the settings are globally implemented.
2. On the port level, the settings are implemented on a per user-defined group of ports basis.
802.1w RSTP
Discarding
Discarding
Discarding
Learning
Forwarding
Table 6- 1. Comparing Port States
802.1d STP
Disabled
Blocking
Listening
Learning
Forwarding
58
Forwarding
No
No
No
No
Yes
Learning
No
No
No
Yes
Yes