Trouble Checks - ProScan PS34190 Owner's Manual

Trouble Checks
Picture poor, sound okay
Check antenna connections.
Adjust sharpness in the Video menu to inprove weak signals. See page 21.
Make sure TV/VCR button on VCR is in the correct position.
Picture okay, no sound
Press VOLUME + or MUTE to restore sound.
Make sure TV's Internal speakers are on. Check the Setup menu of the Audio mode you are using.
Captioning may be set to turn on when TV is muted. See page 35.
Try another channel.
The stereo broadcast may not be clear. Set the Normal Stereo feature to Mono. See page 26.
Make sure sound is not muted. Press MUTE on remote.
Remote Buttons don't work when you press them
Press -IV to set the remote to control the TV. See buttons on page 4.
Unplug set for 15-20 minutes and turn on again.
Remote works part or none of the time
("lear the path between the remote and TV of any objects.
Aim the remote at the component you are trying to control.
Press TV to set the remote will control the TV.
Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries on page 2.
Press any button on the re.mote. If the remote is working, the power indicator on the h'ont of the
TV will flicker when you press a button.
Can't select certain channel
Press number buttons. Channel may not be in the scan list you have selected. See autoprogram on
page 33.
Make sure TV!VCR switch on VCR is in the TV position.
For numbers over 100, press the 100 button, then press the other two numbers.
Set Cable/Air feature to Cable for channels higher than 69. See page 39.
Noisy stereo reception
The stereo broadcast may not be clear. Set the Normal Stereo feature to Mono. See page 26.
No stereo on stereo station
Make sure Stereo is turned on. Set the Normal Stereo feature to Stereo. See page 26.
57