Remote - ProScan PS34190 Owner's Manual

Thesteps belowwill getyourTVconnected
andreadyforwatching.
11. Hook up your TV.
Hook up any antennas or cable to your TV
before you follow the steps below. Details
are in the Connections Section starting on
page 40.
"4. Plug in the TV.
Plug the cord into the outlet, matching the
wide and the small end of the plug with
the outlet.
3. Put Batteries in the Remote.
A. Pull off the cover of the battery
compartment.
B. Place the six AAA batteries as shown,
matching the 4- and -- end of each battery
in each compartment.
C. Replace the cover.
4. Turn on the TV.
Press TV on the Master Remote.
OR
Press POWER on the TV or the small
remote.
5. Place channels in channel
scan list (Autoprogram).
A. Hook up an antenna or cable before you
begin these steps or you will not be able to
add channels to the channel scan list.
B. Press -IV to set the remote to control the
TV.
C Press MENU to bring up the main menu.
D. Highlight Installation using the up and
down arrows on the remote. These arrows
are also shown on the screen.
E. Press 8 to select the Installation menu.
F. Highlight Autoprogram.
G. Press 8 to select Autoprogram and start the
TV adding channels to the channel scan
list.
H. Wait until the TV has finished adding
channels by checking the antennas. The
TV will then tune to the lowest channel
found.
2