Auto Tuning; Or Cable Box - ProScan PS34190 Owner's Manual

Autotuning for the VCR or Cable Box
The Autotuning feature works with VCR1, VCR2/LDISC, and CABLE
on the remote. If Autotuning has been set, pressing the remote's
VCR1, VCR2/LDISC, and CABLE buttons will tune to the TV channel
to see the picture from the component. It will also select the input you
used to connect the component to the TV.
For example, if your VCR is connected as shown on pages 45-46, select
VID1 because the VCR is connected to the TV through the Videol
inputs. Use VID2 for the Video2 inputs and use HiRes for the High
Resolution inputs.
Set up Autotuning
A. Press TV to set the remote to control the
TV.
B. Press MENU to bring up the Main menu
on the screen.
C. Highlight Installation using the remote's
up and down arrows.
D. Press 8 to select Installation.
E. Highlight Autotuning using the remote's
up and down arrows.
F. Press 8 to select Autotuning.
G. Use the up and down arrows to highlight
VCR1, VCR2/LD or CABLE. Press 8 to
select.
H. Select the input you used to connect your
component;either ANT A, ANT B, VID1,
VID2, or HIRES.
I. If you selected ANT A or ANT B, use the
clown arrow to highlight the channel
number. Press 8 to select.
Enter the output channel number of the
VCR or cable box. For the VCR, it should
be set to the position of the CH3/CH4
switch. For cable boxes, the channels are
usually 2, 3 or 4. If you selected VID1,
VID2, or HIRES, you will not need to enter
a channel number.
K. Press 3 to exit.
11