To Restart The System - Nortel BM450 Troubleshooting Manual

26 Chapter 3 Hardware Troubleshooting

To restart the system

Use this procedure to restart the system from the Element Manager.
1
Select Administration > Utilities > Reset.
2
Click the appropriate reset button.
Table 5 lists the Reset functions.
Table 5 Reset functions
Function
Reboot BCM450 System
Warm Reset Telephony
Services
Cold Reset Telephony
Services
Shutdown BCM System
NN40160-700 NN40160-700
Description
Restarts the operating system of the
BCM450 system
Restarts telephony services running
on the BCM450 system
Resets telephony programming of
the BCM450 system to the factory
defaults for that software level
Shuts down the BCM450.
Impact
Temporarily stops all services on the
system. Restarts all services.
This operation does not affect
configuration parameters or
programming.
Restarts all telephony services,
including LAN CTE, Voicemail, and
IP telephony.
This operation does not affect
configuration parameters or
programming.
Affects all telephony services,
including LAN CTE, Voicemail, and
IP telephony.
Telephony services restart with all
telephony programming at default
values for the specified region,
template, and start DN, for the
current software release level.
A cold reset erases voice message
mailboxes and messages if the DN
length is not set to system defaults.
For information about setting the DN
length, refer to the BCM450 Device
Configuration Guide.
Stops all services running on the
system.