80
Chapter 8 Troubleshooting Tools
•
Hunt Group Metrics—Access the Hunt Group metrics to evaluate total call processing by hunt
group member.
•
PSTN Fallback Metrics—View how many fallback attempts and fallback failures occur within
a specific period using the PSTN Fallback Metrics panel.
•
Proactive Voice Quality Management—Proactive Voice Quality Management (PVQM)
metrics allow you to monitor the quality of VoIP calls. You can also use the PVQM metrics to
diagnose infrastructure problems in your network.
For information about monitoring system performance, see the chapter "Monitoring BCM450
Telephony Metrics" in the BCM450 Administration and Security Guide (NN40160-601):
Utilities
BCM450 provides the following utilities:
•
BCM Monitor—BCM Monitor is a stand-alone diagnostic application that the system
administrator can use to view real-time system and IP telephony information about BCM450
systems.
•
Ping—Ping (Packet InterNet Groper) is a utility that you can use to verify that a route exists
between the BCM450 and another device.
•
Route trace—You can use Trace Route to measure round-trip times to all hops along a route.
This helps you to identify bottlenecks in the network.
•
Ethernet activity—The Ethernet Activity panel is a utility that you can use to view ethernet
activity in the BCM450 system.
For information about utilities, see the "BCM450 Utilities" chapter in the BCM450 Administration
and Security Guide (NN40160-601).
Command Line Interface
You can use the Command Line Interface (CLI) to configure basic settings, as well as shut down,
reboot, or reset the BCM450 system. Two CLI modes are available: Maintenance CLI, and
Configuration CLI.
This section contains information about the following topics:
•
Accessing the CLI
•
Using the Configuration CLI
•
Using the Maintenance CLI
Accessing the CLI
There are two methods of accessing the CLI:
•
through a serial connection
•
through the OAM port
NN40160-700
NN40160-700
on page 80
on page 81
on page 82