HP Surestore 64 - Director Switch User Manual page 205

Message
SNMP trap address not defined. An SNMP trap address must be defined if a community name is
Start diagnostics failed. The test
is currently running.
Stop diagnostics failed. The test
is already running.
System diagnostics can not run.
The Operational Status is
invalid.
T
Message
The add firmware process was
aborted.
The data collection process
failed.
The data collection process was
aborted.
The data collection process
failed.
The data collection process was
aborted.
The HP EFC Server is busy
processing a request from
another Product Manager
Cause/Solution
defined. Define an SNMP address.
Diagnostics for the port was already started from the Port
Diagnostics dialog box. Informational message.
Diagnostics for the port was not running and the Stop was
selected on the Port Diagnostics dialog box. Diagnostics quit for
the port for some reason, but the Stop button remains enabled.
Verify port operation. Retry diagnostics for port and select Stop
from the dialog box. If problem persists, contact your service
representative.
System diagnostics cannot run on switches with failed ports.
Replace failed ports.
Cause/Solution
User has ended the add firmware process. N/A. An
informational message.
An error occurred in the data collection process. Contact
support personnel.
User has ended the data collection process. N/A. An
informational message.
An error occurred in the data collection process. Contact
support personnel.
The director did not handle the action. Try action again. If
problem persists, contact your support representative.
The HP EFC Server could not process the current request
because it is busy handling a request from another Product
Manager. Retry the operation later. If the condition persists,
contact support personnel.
Appendix 189