[Rcu] Delete Path - HP StorageWorks P9000 - Disk Arrays Reference Manual

+{S/N,MCU LDKC,MCU,RCU LDKC,SSID,Controller ID,Min.Path,
MIH Time(s),Round Trip Time(ms),FREEZE}
={99999,0x00,0x3F,0x00,0x0004,4,08,015,001,Disable}
Detailed Information
Item
S/N
MCU LDKC
RCU LDKC
Path Gr.ID
Controller ID
MCU
SSID
Min.Path
MIH Time(s)
Round Trip Time(ms)
FREEZE

[RCU] Delete Path

Example 1: CU Free is used
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[RCU],Delete Path,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{S/N,MCU LDKC,RCU LDKC,Path Gr.ID,Controller ID}
={99999,0x00,0x00,Default,4}
++{MCU Port,RCU Port}=[{1E,3E},{5E,7E},{1F,3F},{5F,7F},
{1G,3G},{5G,7G},{1H,3H}],Num. of Port Pairs=7
Example 2: CU Free is not used
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[RCU],Delete Path,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{S/N,MCU LDKC,MCU,RCU LDKC,RCU,SSID,Controller ID}
={99999,0x00,0x3F,0x00,0x7F,0x0004,5}
++{MCU Port,RCU Port}=[{1E,3E},{5E,7E},{1F,3F},{5F,7F},
{1G,3G},{5G,7G},{1H,3H},{5H,7H}],Num. of Port Pairs=8
Detailed Information
Item
S/N
MCU LDKC
Description
Indicates a serial number of the RCU device where the RCU option setting is changed.
The LDKC number of the connected LDKC.
The LDKC number of the paired LDKC.
The RCU path group ID where the RCU optional setting is changed. When the path group ID
is default setting, "Default" is output.
The controller ID of the RCU where the optional setting is changed.
The CU number of the connected CU.
Indicates SSID of the RCU where the optional setting is changed.
The minimum number of paths after change.
The value of RIO MIH (Remote I/O Missing Interrupt Handler) timer (wait time until data copy
from MCU to RCU is completed). The unit represents seconds.
The round-trip response time (delay time for round-trip remote I/O) after change. The unit is in
milliseconds. This value is output when Continuous Access Synchronous or Continuous Access
Synchronous Z is used.
Indicates whether CGROUP (FREEZE/RUN) PPRC TSO command support is enabled or disabled.
This value is output only when Continuous Access Synchronous Z is used.
Enable or Disable is output.
Description
The serial number of the device of RCU where the path has been deleted.
The LDKC number of the connected LDKC.
RCU Descriptions 135