Getclustermaxconfiguredpackages; Setclustermaxconfiguredpackages; Getclusterntplocalmaster; Setclusterntplocalmaster - HP StorageWorks NAS 8000 - Version 1.6.X Command Reference Manual

getClusterMaxConfiguredPackages

Gets the value from the registry.

setClusterMaxConfiguredPackages

Stores the number in the registry.

getClusterNtpLocalMaster

Stores the number in the registry.

setClusterNtpLocalMaster

Assigns one of the cluster nodes to be an NTP master server for time synchronization.
Establishes a stratum 10 NTP server on one node, other nodes are made to synchronize with
the local master.

getClusterCallTimeout

Returns the value from the registry.

restartClusterAntivirus

Executes restartClusterNodeAntivirus on all cluster nodes.

restartClusterNodeAntivirus

Restarts the antivirus software.

Cluster Package Commands

The following commands let you configure and control failover packages.

addClusterPackage

Creates a default package configuration and a placeholder in the registry. This must be called
before other calls to setClusterPackageXYZ text commands. The package is defined in the
registry, with some default values, but not defined in the cluster.

applyClusterPackageConfiguration

Creates a cluster package using either default values or values set by other
setClusterPackageXYZ commands. After this completes, the package is known to the cluster,
but not running.
HP StorageWorks NAS 8000 Command Reference
OutParam[0] = Maximum number of packages allowed to run
InParam[0] = Maximum number of packages allowed to run
OutParam[0] = Hostname or IP address of cluster node that is currently serving as an NTP
master server for time synchronization.
InParam[0] = Cluster node name
InParam[1] = Cluster node IP address
OutParam[0] = Timeout, in seconds
InParam[0] = Package name
InParam[0] = Package name
Command Reference
77