Getnetworkcardtransmitbytes; Getnetworkcardtransmitcollisions; Getnetworkcardtransmitpackets; Network Card Bonding - HP StorageWorks NAS 8000 - Version 1.6.X Command Reference Manual

Command Reference

getNetworkCardTransmitBytes

Returns the number of bytes transmitted by the specified NIC since any NIC configuration
changes were made.

getNetworkCardTransmitCollisions

Returns the number of transmit collisions experienced by the specified NIC since any NIC
configuration changes were made.

getNetworkCardTransmitPackets

Returns the number of packets transmitted by the specified NIC since any NIC configuration
changes were made.

Network Card Bonding

When you configure NIC ports, you have the option of enabling bonding, a failover
mechanism that automatically switches a specific NIC port to a standby network upon the
failure or abnormal termination of the currently active system. By default, the
lowest-numbered NIC provides the addresses of the bond channel, but you can change the
addresses manually.
Note:
DHCP or NIC bonding disables manually configuring addresses.The following commands are used
to configure NIC bonding.

getNetworkCardBondMasterEnabled

Identifies whether the specified NIC is a bond master.

getNetworkCardBondSlaveEnabled

Identifies whether the specified NIC is a bond slave.

bondEnslaveNetworkCard

Sets the specified NIC to be a bond slave of the specified master NIC.
22
inParam[0] = Network card name
outParam[0] = Transmit byte count
inParam[0] = Network card name
outParam[0] = Transmit collision count
inParam[0] = Network card name
outParam[0] = Transmit packet count
Enabling DHCP disables NIC bonding and enabling NIC bonding disables DHCP. Enabling
inParam[0] = Network card name
outParam[0] = T (Enabled) or F (Disabled)
inParam[0] = Network card name
outParam[0] = T (Enabled) or F (Disabled)
inParam[0] = Network card name
inParam[1] = Bond master card handle
HP StorageWorks NAS 8000 Command Reference