getClusterName
Gets the name of the cluster stored in the registry.
setClusterName
Stores the name in the registry. Does not take effect until applyClusterConfiguration is
called.
getClusterStatus
Gets status information about the cluster, nodes, and packages.
getClusterQsHost
Gets the name of the Quorum server stored in the registry.
setClusterQsHost
Stores the name of the Quorum server in the registry. This command is required before
executing applyClusterConfiguration.
getClusterAutoStartEnabled
Gets the AutoStartEnabled value from the registry,
setClusterAutoStartEnabled
Stores the value in the registry and also updates the cluster configuration to reflect the change.
If enabled, each node will attempt to join the cluster at boot time. If disabled, the cluster must
be started manually using startCluster.
getClusterNodeNameList
Gets the list of nodes in the cluster.
setClusterNodeNameList
Stores the list of nodes in the cluster in the registry.
getClusterHeartbeatNetworkCardList
Gets the list of network card interfaces used for heartbeats as they are stored in the registry.
setClusterHeartbeatNetworkCardList
Stores the list in the registry. Is required before calling applyClusterConfiguration.
HP StorageWorks NAS 8000 Command Reference
OutParam[0] = Cluster name
InParam[0] = Cluster name
OutParam[0] = A multi-line text string that contains status information about the cluster,
including nodes and packages running on those nodes.
OutParam[0] = Quorum server name
InParam[0] = Cluster name
OutParam[0] = T (enabled), or F (disabled)
InParam[0] = T (enabled), or F (disabled)
OutParam[0:N] = List of node names
InParam[0:N] = List of node names
OutParam[0:N] = Network card interface list
Command Reference
75