Getnetworknisdomainname; Setnetworknisdomainname; Getnetworknisenabled; Setnetworknisenabled - HP StorageWorks NAS 8000 - Version 1.6.X Command Reference Manual

Command Reference

getNetworkNisDomainName

Returns the NIS domain name.

setNetworkNisDomainName

Sets the NIS domain name for the HP NAS 8000.

getNetworkNisEnabled

Returns whether the HP NAS 8000 is NIS enabled.

setNetworkNisEnabled

Enables or disables NIS for the HP NAS 8000.

getNetworkNisCurrentServerName

Returns the name of the NIS server the HP NAS 8000 system is currently connected to.

getNetworkNisServerName

Returns the name of the NIS server the HP NAS 8000 will attempt to connect to at boot.

setNetworkNisServerName

Sets the NIS server the HP NAS 8000 system will attempt to connect to at boot.

Network SNMP Settings

If you are using a Simple Network Management Protocol (SNMP) tool, you can define the
names or IP addresses of hosts to receive notification in case of an event.
This information is optional and does not affect the functionality of the device. In the event of
a hardware failure or system alert, messages are sent via SNMP traps, email (SMTP), and
logged in the system log.

getNetworkSnmpTrapDestVersion

Returns the version of SNMP protocol to use when sending a trap to this Trap Destination
(currently only v1 and v2c are supported; default: v1).

getNetworkSnmpCommunityString

Returns the SNMP community name for this device (default: public).
26
outParam[0] = NIS domain name
inParam[0] = NIS domain name
outParam[0] = T (Enabled) or F (Disabled)
inParam[0] = T (Enable) or F (Disable)
outParam[0] = Current NIS server name
outParam[0] = NIS server name
inParam[0] = NIS server name
inParam[0] = Destination number
outParam[0] = Value
outParam[0] = SNMP community name
HP StorageWorks NAS 8000 Command Reference