Getsystemsyslogservername; Setsystemsyslogservername; Getsystemupsstatus; Getsystemupslist - HP StorageWorks NAS 8000 - Version 1.6.X Command Reference Manual

getSystemSyslogServerName

Returns the name of the remote syslog server.

setSystemSyslogServerName

Defines the remote server to which system log entries will be sent.

UPS Settings

If you connected the optional APC Symmetra UPS to your HP NAS 8000 during installation,
the NAS server attempts to communicate with the UPS through a serial connection. The APC
UPS has only one serial port. The NAS server, however, has two ports. Connect the UPS serial
port to the COM1 port on the back of the NAS server.

getSystemUpsStatus

Returns the status of the attached supported UPS.
Values:

getSystemUpsList

Returns a list of the names of supported UPS systems.

getSystemUpsEnabled

Returns the name of the attached enabled UPS.

setSystemUpsEnabled

Sets the name of the attached enabled UPS.

getSystemUpsTitle

Returns the system title of the specified UPS.
HP StorageWorks NAS 8000 Command Reference
outParam[0] = Syslog server name
inParam[0] = Syslog server name
outParam[0] = Status
outParam[0] = Status
normal: UPS support is currently disabled.
APC UPS is normal: UPS support is enabled for APC and is functioning normally.
APC UPS fail to attach: UPS support is enabled for APC but the system cannot
communicate with the UPS.
APC UPS comm is pending: UPS support is enabled for APC. The system is in the process
of establishing communications.
APC UPS unknown error:xxxx: An unexpected error has occurred. "xxxx" will display
information about the error.
outParam[0:N] = List of UPS names
outParam[0] = Name of enabled UPS
inParam[0] = Name of UPS
inParam[0] = Name of UPS
outParam[0] = Title of UPS
Command Reference
65