Command Reference
getNetworkSnmpTrapDestPort
Returns the port set for the SNMP trap (default: 162).
setNetworkSnmpTrapDestPort
Sets the port number for the SNMP trap (default: 162).
setNetworkSnmpTrapDestStatus
Sets the Status for this Trap Destination. See
on trap status.
getNetworkSnmpTrapDestStatus
Returns the Status for this Trap Destination. See
information on trap status.
getNetworkSnmpTrapDestList
Returns the complete list of Trap Destination Addresses.
setNetworkSnmpTrapDestList
Sets the complete list of Trap Destination Addresses. Deletes all current Trap Destinations,
and creates new ones based on this list of addresses. (Status is set to "active"; all other
parameters are not created, and will return defaults).
getNetworkSnmpActiveTrapDestList
Returns the complete list of "active" Trap Destinations.
getNetworkSnmpCommunityString
Returns the SNMP community name for this device (default: public).
setNetworkSnmpCommunityString
Sets the SNMP community name for this device (default: public).
28
inParam[1] = Value
inParam[0] = Destination number
outParam[0] = Port
inParam[0] = Destination number
inParam[1] = Port
inParam[0] = Destination number
inParam[1] = Value
inParam[0] = Destination number
outParam[0] = Value
outParam[0:N] = List of trap destination hostnames or IP addresses
inParam[0:N] = List of trap destination hostnames or IP addresses
outParam[0:N] = List of trap destination hostnames or IP addresses
outParam[0] = SNMP community name
inParam[0] = SNMP community name
www.hp.com/support/nas8000
www.hp.com/support/nas8000
HP StorageWorks NAS 8000 Command Reference
for information
for