Table of Contents
Advertisement
28
C. RAPID KEY/SPEED-DIAL/SECONDARY AUTODIAL NUMBERS
The built-in autodialer of the FO-220 can hold up to 32 telephone numbers for
fax use and another 32 telephone numbers for voice (regular phone) calls. Each
fax and phone number is assigned a 2-digit speed-dial code, 01 to 32. Num-
bers with a code of 01 to 12 are also automatically assigned to one of the twelve
corresponding rapid keys. A fax number with a speed-dial code of 01 to 12 (us-
ing a rapid key) can also have a secondary "back-up" telephone number as-
signed to the same code-which is automatically called if the primary number
is busy.
NOTES:
If waiting time is required for a second dial tone when dialing (for example,
if your machine is connected to an extension), add a Pause when entering
the telephone number by using the REDIAL key.
Example: Enter "9':
tered by pressing the REDIAL key. The display indicates 'c' for a pause.
One pause gives a time delay of approximately 2 seconds. It is possible
to enter two or more pauses.
Enter a "1" before the area code in dialing locations where required.
If rapid key 10, 11 or 12 is used as a Program-Dial Key, a Rapid-Dial telephone
number cannot be assigned to the same key.
To check any entered or cleared autodialing data, print-out and refer to the
Telephone List (see p.102). Post the new Telphone List near the machine for
reference.
When a Rapid-Dial number (speed-code 01-12) is entered or changed, write-in
the location name on the keypad label provided (see p.111).
If incorrect data is entered during the procedure, press the STOP/C key to
erase the previously-entered data, then enter the correct data.
V. PROGRAMMING
Pause" and "telelphone number". The pause is en-
Advertisement
Table of Contents
