Table of Contents
Advertisement
A. INSTALLATION
Install the machine on a level surface.
1.
2.
Keep the machine away from air conditioners, heaters, direct sunlight,
humidity, and dust.
3.
Provide easy access to the front, back, and sides of the machine.
4.
Avoid locations where the transceiver may be splashed by water or chemi-
cals.
A modular telephone jack must be located near the machine.
5.
A 120 VAC, 60 Hz isolated and grounded (three-prong) outlet is required.
6.
7.
In area's that experience high incidences of lightning or power surges, a
surge protector is recommended for the power and phone lines.
B. OPERATION
1.
Do not open the machine during operation (transmitting, receiving, or
copying).
2.
Verify that the LCD (display) message is "STAND-BY". This means the
machine is ready for facsimile operation.
Use only the proper recording paper. Store the paper in a well ventilated,
3.
shaded, cool place. Sharp FO-20PR6 paper is recommended.
4.
Operate the machine according to the operating procedures described in
this manual.
5.
Remove any paper clips or staples from the documents to be transmitted
to prevent damage to the transceiver.
6.
Make sure that the documents are completely dry.
7.
Thick paper, newsprint, cloth, and other types of similar material should never
be used. Such originals should be photocopied and the copies should be
used for transmitting.
When documents are copied or received continuously for a long period of
8.
time, the recording head overheat protection function becomes active and
as a result, facsimile operation halts. (When the documents are received
in G3 mode, your facsimile unit automatically requests voice communica-
tion to the transmitting machine.) Wait for a while and the facsimile will au-
tomatically reset.
II. PRECAUTIONS
Advertisement
Table of Contents
