Removing
240V
120V
4
1
2
1
Power off the printer and disconnect the power cord from
the power outlet.
Removing the hard drive while the printer is
powered on may cause a malfunction.
2
Open the rear cover.
Be careful not to touch the fuser. It becomes
very hot from printing.
3
Remove the side cover by (1) pressing in, (2) sliding,
(3) pulling it out from the bottom and (4) down.
3
4
Remove the two screws that secure the controller board's
access cover.
Chapter 6: Installing Printer Options
Hard Disk Drive
6-41