Replacing The Fuser - Xerox DocuPrint N2025 System Administrator Manual

Maintenance Kit Instructions

Replacing the Fuser

240V
120V
4-10 System Administrator Guide
The fuser is used for fusing toner onto paper, and has a life
expectancy of approximately 200,000 impressions
(though, depending on how the printer is used, it may
require replacement before that number is reached).
To replace the fuser with a new one, follow the steps listed
below.
To avoid electric shock, be sure to power off and
unplug the printer before beginning this procedure.
To avoid burns, wait at least 40 minutes after
powering off the printer to allow the fuser to cool
down, and never touch the heater area (where a
warning label is located). If paper is jammed at the
heater or roller area, do not attempt to remove it
by force. Instead, contact Customer Support Center
for assistance.
1 Power off the printer and disconnect the power cord.