Tray Sequence Rules - Xerox DocuPrint N2025 System Administrator Manual

Tray Sequence Rules

When you define a Tray Sequence, the printer searches
the input trays for the correct size and type of paper for
each job that is submitted.
• If you do not specify an input tray when sending a job
to the printer (e.g., no paper source command is sent,
or the paper source is set to "Auto" in PCL), the trays
included in the Tray Sequence are searched first (in the
sequence order), before other trays not in the
sequence.
• If you specify an input tray when sending a job to the
printer, and that tray is included in the Tray Sequence,
the printer will check that tray for the correct size and
type of paper.
— If the tray contains the correct paper, then it is
used.
— If the tray does not contain the correct paper (e.g.,
it contains other paper or is empty), the other trays
in the sequence are searched.
- If any of these trays contains the correct paper,
then it is used.
- If any of these trays are set to the correct paper
size and type but all of the trays in the sequence
are empty, then the printer will prompt you to
load paper into the specified tray.
- If no trays in the sequence are set to the correct
paper size and type, then the remaining trays are
searched. If there are no trays that can satisfy the
request, then the printer will prompt you to load
paper into the specified tray.
• If you include "MBF" in the Tray Sequence setting, a
request to feed paper from any other tray in the
sequence will be overridden and the printer will
attempt to feed paper from the multi bypass feeder
first. If the multi bypass feeder is out of paper, then the
other trays in the sequence are searched.
Chapter 1: Configuring the Printer
Configuring Automatic Tray Switching
1-117