Xerox DocuPrint N2025 System Administrator Manual page 191

Table 5.1 Control Panel Messages (continued)
Message
Ready
Remove Output
From Offset Bin
Remove Output
From Std. Bin
Remove PrintCart
Clear Paper Path
Toner Low
Tray 1 Jam-
Open Tray 1
Tray 2 Failure
Power Off/On
Tray 2 Jam-
Open Tray 2
Explanation/Corrective Action
The printer is online and ready to print.
The Offset Bin (Offset Catch Tray) is full. Empty the bin to resume printing.
The Standard Bin is full. Empty the bin to resume printing.
Part of a sequence of messages following an initial paper jam message.
Remove the laser print cartridge and any jammed paper, close the covers,
then refer back to the Control Panel for further messages.
The toner in the laser print cartridge is low. The printer will continue to
print, but over time print quality will deteriorate. Replace the laser printer
cartridge.
A paper jam has occurred at or before the input sensor when feeding
paper from Tray 1. Remove Tray 1 from the printer, then refer back to the
Control Panel for further messages.
Tray 2 when installed with a 500 sheet feeder or when installed with a
2000 sheet feeder has failed. Power off and power on the printer. If the
problem persists, contact your Customer Service Center.
A paper jam has occurred at or before the input sensor when feeding
paper from Tray 2.
• If Tray 2 is a 500 sheet feeder, remove Tray 2 from the printer.
• If Tray 2 is a 2,000 sheet feeder, open the feeder's paper tray
Then refer back to the Control Panel for further messages.
Control Panel Messages
Table 5.1 Page 9 of 10
Chapter 5: Troubleshooting 5-13